How to control the display parts of ISO-surface of vortex region ？

wyungh · April 4, 2015, 03:42

Hi everybody,

As I obtain the vortex region with using the Q-criterion in the tecplot 360 EX 2015, then I want to display

the ISO-surface for one value of Q, but I just want to display some parts of the

ISO-surface,what should I do?

Thank you !

JerimiahLee · April 6, 2015, 11:29

Hello,

If the region you want to view can be determined by existing variables you can use Blanking to hide the region you do not care about. Use Plot > Blanking > Value Blanking to set this up. Once set up, you then need to go to the Iso-surface details screen and on the Style Tab set the Obey Source Blanking.

April 4, 2015, 03:42	How to control the display parts of ISO-surface of vortex region ？	#1
wyungh New Member yohenng Join Date: Nov 2014 Location: China University of Mining &Technology Posts: 3 Rep Power: 12	Hi everybody, As I obtain the vortex region with using the Q-criterion in the tecplot 360 EX 2015, then I want to display the ISO-surface for one value of Q, but I just want to display some parts of the ISO-surface,what should I do? Thank you !

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 05:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 05:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 09:19

April 6, 2015, 11:29		#2
JerimiahLee New Member Jerimiah Join Date: May 2014 Location: Bellevue, Washington Posts: 13 Rep Power: 16	Hello, If the region you want to view can be determined by existing variables you can use Blanking to hide the region you do not care about. Use Plot > Blanking > Value Blanking to set this up. Once set up, you then need to go to the Iso-surface details screen and on the Style Tab set the Obey Source Blanking.