 |
 |
 |
|
|
|
[Sponsors] | ||||
February 21, 2024, 03:17
|
dynamic library not found
|
#1 |
|
New Member
Eryn
Join Date: Apr 2023
Posts: 8
Rep Power: 3  |
Hello and good afternoon.
May I ask on how I can copy and paste the dynamic library for zigzag simulation ? I already copied the needed file for this simulation and paste at the project file, but when I running the simulation, it get crashed and the error is about dynamic library is required for motion law for this computation but dynamic library is not found please copy the dynamic libarry to the computational folder and launch the computation again so is it because i wrongly copied and paste the file ? Thank you in advance |
|
|
|
|
|
June 22, 2024, 16:12
|
|
#2 |
|
Senior Member
Marcin
Join Date: May 2014
Location: Poland, Swiebodzin
Posts: 313
Rep Power: 13 |
Try these tips in the link below
https://howtooansys.blogspot.com/202...nfoam-how.html
__________________
Quick Tips and Tricks, Tutorials FLuent/ CFX (CFD) https://howtooansys.blogspot.com/ |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two phase flow in porous medium | Milaad | OpenFOAM | 7 | July 1, 2024 06:08 |
| [RapidCFD] Discussion thread on how to install and use RapidCFD | newoscar | OpenFOAM Community Contributions | 88 | May 17, 2024 10:39 |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| Gmsh installation on terminal help | spitfire | Main CFD Forum | 4 | July 27, 2017 16:11 |
| OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
Linear Mode
