[muzili]

The calculation results of our model are based on the momentum conservation equation and the energy conservation equation, but we are asked to provide "Ansys workbench has a bunch of codes in it. What authors need to specify is which code is used to simulate the momentum and energy equation. It must be Ansys Fluent."

As far as I know, Ansys is not open source.Experts want to know how we set up the solution in ANSYS Fluent, instead of knowing what specific procedures are used to solve the equation in ANSYS Fluent. Am I right?

If you can help us answer this question, we would be very grateful.

[arjun]

At least this part should be clear when you set up the simulation. Ansys has - Fluent, Polyflow and CFX as flow solvers. You need to find out what it is using for the work you did. It is most probably using Fluent but you need to inspect the set up to see which one of these three it used to run the simulation.


You do not need to see the source code to see this.

[muzili]

Originally Posted by arjun

At least this part should be clear when you set up the simulation. Ansys has - Fluent, Polyflow and CFX as flow solvers. You need to find out what it is using for the work you did. It is most probably using Fluent but you need to inspect the set up to see which one of these three it used to run the simulation.


You do not need to see the source code to see this.

Thank you very much for your answer.
What do you mean: experts want to know how we set up the solution in ANSYS Fluent, instead of knowing what specific procedures are used to solve the equation in ANSYS Fluent. Am I right?
Thank you.