 |
 |
 |
|
|
|
[Sponsors] | ||||
December 6, 2024, 13:55
|
SU2 Center of Pressure
|
#1 |
|
New Member
Gui Cayser
Join Date: Dec 2024
Posts: 1
Rep Power: 0  |
Dear all,
I have been using SU2 to run some airfoil simulations, however, when it comes to the calculation of the center of pressure at AoA = 0, I get a value completely different from all other values of AoA. I understand that SU2 gives the CoP as the equation of a line. Question 1: Why is it given in that form? Question 2: When I have an equation such as X=0.012230Y+0.266907 m, is the value of Y defined by the user or can it be calculated somehow? Thank you. |
|
|
|
|
 |
| Tags |
| center of pressure, cfd, forces_breakdown, output, su2 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How is total pressure calculated? | looee | CFX | 15 | October 30, 2019 09:14 |
| Pressure Inlet Boundary Conditions | Mr.Goodcat | FLUENT | 5 | June 20, 2019 02:47 |
| Periodic flow using Cyclic - comparison with Fluent | nusivares | OpenFOAM Running, Solving & CFD | 30 | December 12, 2017 06:35 |
| Discharge of Pressure Vessel into Pipe with Regulator | gajowni2 | System Analysis | 0 | October 31, 2015 19:57 |
| Setting up the pressure variation due to tornado in a duct(UDF)+animation | guillaume1990 | FLUENT | 0 | March 3, 2014 12:59 |
Linear Mode
