[bgulzar22]

Dear SU2 Community,

I hope this message finds you in good health and spirits.

I am writing to seek your assistance regarding an issue I am facing while implementing a temperature boundary condition on the 'WALL' marker in my SU2 simulation. Despite thorough efforts and troubleshooting, I have been unable to resolve the problem, and I am reaching out to the community for guidance and support.

To provide a clear understanding of the issue and aid in troubleshooting, I have attached the output message I am receiving.
Additionally, I am sharing a link that includes the following files:

Configuration file (cfg)
Mesh files
Python script
Temperature file
Link: https://drive.google.com/drive/folde...usp=drive_link

The specific error message I am encountering is related to the 'WALL' marker not being recognized in the simulation. I have validated the marker's existence, reviewed naming conventions, and checked the logic in my code, but the issue persists.

If any of you have experience or insights into implementing temperature boundary conditions or working with markers in SU2 simulations, I would greatly appreciate your help. Your expertise and guidance could significantly contribute to resolving this issue and advancing my project.

Thank you for considering my request, and I look forward to hearing from you soon.