|
[Sponsors] |
SU2 7.1.1 Test Case Aeroelastic Simulation slow in parallel ? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Senior Member
Sultan Islam
Join Date: Dec 2015
Location: Canada
Posts: 140
Rep Power: 10 ![]() |
Hello everyone,
So I noticed that if i compile SU2 with support for AD forward, the aeroelastic test case runs awefully slow in parallel, seems like the process goes to sleep and then wakes up and runs a bit and sleeps again. However i ran it with a version compiled without AD forward support and it runs fine? Anyone know why? Im using Fedora 34 with gcc 11 and openmpi 4.1.1. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Sultan Islam
Join Date: Dec 2015
Location: Canada
Posts: 140
Rep Power: 10 ![]() |
Well I found out why it was happening. I accidently compiled one with mpi+threads. That's why my system was spawning many threads and half of them were sleeping. I guess that would be good for over network with shared memory.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Windturbine simulation in SU2 | k.vimalakanthan | SU2 | 15 | October 12, 2023 05:53 |
Problem running movingCylinders case in parallel with foam-extend-3.1 | mhkenergy | OpenFOAM Running, Solving & CFD | 5 | March 3, 2017 05:20 |
SU2 Quickstart case computation time increases in parallel | wrik | SU2 | 2 | July 20, 2016 20:28 |
SU2 2.0.6 test case execution errors | austin.m | SU2 Installation | 4 | October 4, 2013 09:30 |
Problem with parallel python scripts for dual time stepping test case | sss3700 | SU2 | 1 | March 5, 2013 13:30 |