 |
 |
 |
|
|
|
[Sponsors] | ||||
June 23, 2021, 11:21
|
Continue time-averaging after restart
|
#1 |
|
New Member
Ioannis Mandralis
Join Date: May 2021
Posts: 7
Rep Power: 5  |
Dear all,
I noticed that after I restart a simulation with COMPUTE_AVERAGE=YES and TIME_AVERAGE in the volume output field, the time averaged quantities are computed again from scratch. I would like to be able to continue the time averaging after the simulation is restarted. How can this be done ? Thanks in advance |
|
|
|
|
|
June 27, 2021, 05:22
|
|
#2 |
|
Senior Member
Pedro Gomes
Join Date: Dec 2017
Posts: 466
Rep Power: 14 |
Hello,
There is no built-in way to do this in SU2. You would need to combine the two averages manually. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 30 | November 6, 2023 22:00 |
| [Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 03:36 |
| Starting field averaging using libFunctionObject after certain time | eelcovv | OpenFOAM Programming & Development | 25 | December 7, 2015 23:28 |
| same geometry,structured and unstructured mesh,different behaviour. | sharonyue | OpenFOAM Running, Solving & CFD | 13 | January 2, 2013 23:40 |
| calculation diverge after continue to run | zhajingjing | OpenFOAM | 0 | April 28, 2010 05:35 |
Linear Mode
