Reading DGFEM mesh

jas_z · July 11, 2020, 09:39

hello su2-ers,

i am trying to run the SphereViscous test case with SU2-v7.0.6:
https://github.com/su2code/TestCases/tree/master/hom_navierstokes/SphereViscous/nPoly3_QuadDominant

when i run the configuration file, and after the markers are parsed, i get the following error:

Error in "void CDriver::Geometrical_Preprocessing_DGFEM(CConfig*, CGeometry**&)":
-------------------------------------------------------------------------
Geometrical_Preprocessing_DGFEM: Coarse grid levels not implemented yet.

is there any other way i can import the grid and run the test?
or, perhaps, some way to bypass the error?

thank you in advance,
jason.

pcg · July 11, 2020, 17:01

It should not be a problem with the mesh, try MGLEVEL= 0 in your config file.

jas_z · July 12, 2020, 10:19

thanks a lot! it now works!

July 11, 2020, 09:39	Reading DGFEM mesh	#1
jas_z New Member jas z Join Date: Dec 2009 Location: athens Posts: 6 Rep Power: 17	hello su2-ers, i am trying to run the SphereViscous test case with SU2-v7.0.6: https://github.com/su2code/TestCases/tree/master/hom_navierstokes/SphereViscous/nPoly3_QuadDominant when i run the configuration file, and after the markers are parsed, i get the following error: Error in "void CDriver::Geometrical_Preprocessing_DGFEM(CConfig, CGeometry*&)": ------------------------------------------------------------------------- Geometrical_Preprocessing_DGFEM: Coarse grid levels not implemented yet. is there any other way i can import the grid and run the test? or, perhaps, some way to bypass the error? thank you in advance, jason.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can't get chtMultiRegionSimpleFoam to working.	shiromaniac	OpenFOAM Running, Solving & CFD	11	October 18, 2021 09:40
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
foam-extend-4.1 release	hjasak	OpenFOAM Announcements from Other Sources	19	July 16, 2021 06:02
problem when converting mesh (made by ICEM) using fluentMeshToFoam	Forrest_Lei	OpenFOAM	11	October 16, 2009 07:28
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 16:02

July 11, 2020, 17:01		#2
pcg Senior Member Pedro Gomes Join Date: Dec 2017 Posts: 466 Rep Power: 14	It should not be a problem with the mesh, try MGLEVEL= 0 in your config file.

July 12, 2020, 10:19		#3
jas_z New Member jas z Join Date: Dec 2009 Location: athens Posts: 6 Rep Power: 17	thanks a lot! it now works!