[codezy]

Dear developers and users, I have some troubles about the TestCases. May somebody please help me?

My SU2 version is 3.0.0 "eagle" . And my configure are: "CXX=icpc" without metis and cgns. Here are the troubles:

I cannot run some TestCases:
* cont_adj_navierstokes/naca0012
* euler/channal
* euler/dlrt6
* euler/lowmach_oneram6
* fluid_structure/beam2D
* fluid_structure/beam3D
* linear_elasticity (segmentation fault)
* mesh_deformation/oneram6
* optimization_rans/steady_oneram6
* rans/nasacrm
* rotating/caradonna_tung
* rotating/open_rotor
* wave/cylinder

I ran the cases above used serial mode. So what's the problems are there?

[hlk]

Hello,
I did a quick check on my machine using the most recent release, and found that at least a couple of the cases you mentioned ran. For some of the test cases which are not used in the training tutorials at http://adl-public.stanford.edu/docs/...%27s+Tutorials it is possible that some settings would need to be adjusted, however that would not explain the seg fault you mention.

A few options for troubleshooting:
- go through the tutorials and make sure that you are using the correct commands.
- reconfigure and reinstall the code
- pull the 3.0.0 release from github (rather than the most recent developer release) and reinstall
- pull the most recent release (in which whatever bugs you encountered may have been fixed) and reinstall.

[codezy]

Originally Posted by hlk

Hello,
I did a quick check on my machine using the most recent release, and found that at least a couple of the cases you mentioned ran. For some of the test cases which are not used in the training tutorials at http://adl-public.stanford.edu/docs/...%27s+Tutorials it is possible that some settings would need to be adjusted, however that would not explain the seg fault you mention.

A few options for troubleshooting:
- go through the tutorials and make sure that you are using the correct commands.
- reconfigure and reinstall the code
- pull the 3.0.0 release from github (rather than the most recent developer release) and reinstall
- pull the most recent release (in which whatever bugs you encountered may have been fixed) and reinstall.

Thank you very much! I'd like to try a new release later.