[leo_NM]

Good night

I'm trying to use one of my meshes in SU2. I exported it with cgns 2.4.

I don't know if the problem in the image is due the mesh or the setup.

has anyone ever had this problem ?

thanks !

[Tommy Chen]

Originally Posted by leo_NM

Good night

I'm trying to use one of my meshes in SU2. I exported it with cgns 2.4.

I don't know if the problem in the image is due the mesh or the setup.

has anyone ever had this problem ?

thanks !

It seems that the iteration has already run over 300 steps, so the mesh should be OK, maybe you can reduce the CFL number.

You see , at iteration 340, the residual obviously jump much higher than previous step.

[Tommy Chen]

Originally Posted by Tommy Chen

It seems that the iteration has already run over 300 steps, so the mesh should be OK, maybe you can reduce the CFL number.

You see , at iteration 340, the residual obviously jump much higher than previous step.

Sorry , the jump is at the final step 344

[leo_NM]

It worked ! thank you !