problems in optimization of ONERAM6

mk1989 · October 18, 2013, 01:18

I used the tutorial 9, I first did the parallel_computation -f inv_ONERAM6.cfg -p 2, then I change DIRECT to ADJOINT, and ran parallel_computation -f inv_ONERAM6.cfg -p 2, but I only get the result of restart_adj_cd.dat and don't have the restart_adj_cl.dat, how can I get the restart_adj_cl.dat?
Wish the help from u!!!

economon · November 19, 2013, 17:38

Hi,

Note that you will have to run 2 separate adjoint problems for the two different objectives. It appears that you have run the adjoint problem for the drag, but you will also have to run it for the lift objective by changing the ADJ_OBJFUNC option in the config file from DRAG to LIFT. After you change it to LIFT and converge that problem, you will have restart_adj_cl.dat available.

Hope this helps,
Tom

October 18, 2013, 01:18	problems in optimization of ONERAM6	#1
mk1989 New Member LeeJack Join Date: Sep 2013 Posts: 5 Rep Power: 13	I used the tutorial 9, I first did the parallel_computation -f inv_ONERAM6.cfg -p 2, then I change DIRECT to ADJOINT, and ran parallel_computation -f inv_ONERAM6.cfg -p 2, but I only get the result of restart_adj_cd.dat and don't have the restart_adj_cl.dat, how can I get the restart_adj_cl.dat? Wish the help from u!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 12:12
[mesh manipulation] Problems with rotational cyclic boundaries	TReviol	OpenFOAM Meshing & Mesh Conversion	8	July 11, 2014 04:45
Needed Benchmark Problems for FSI	Mechstud	Main CFD Forum	4	July 26, 2011 13:13
Two-phase air water flow problems by activating Wall Lubrication Force	challenger85	CFX	5	November 5, 2009 06:44
Adaptive optimization of geometry	Jan Rusås	CFX	1	September 16, 2000 03:38

November 19, 2013, 17:38		#2
economon Super Moderator Thomas D. Economon Join Date: Jan 2013 Location: Stanford, CA Posts: 271 Rep Power: 14	Hi, Note that you will have to run 2 separate adjoint problems for the two different objectives. It appears that you have run the adjoint problem for the drag, but you will also have to run it for the lift objective by changing the ADJ_OBJFUNC option in the config file from DRAG to LIFT. After you change it to LIFT and converge that problem, you will have restart_adj_cl.dat available. Hope this helps, Tom