 |
 |
 |
|
|
|
[Sponsors] | ||||
August 4, 2022, 13:30
|
Modelling of Non-classical damping in ANSYS
|
#1 |
|
New Member
Karim
Join Date: Aug 2022
Posts: 1
Rep Power: 0  |
Hi everyone,
I hope everyone is well, I am creating a finite element model of a cantilever beam with the ultimate goal of finding the modal characteristics of the beam, i.e.(Modal frequencies, damping ratio, and mode shapes). However, this beam has been successfully modelled using the undamped model. I want to extend it to a damped model to simulate complex mode shapes. To do this, I want to add dampers at any vertical DOF so that the orthogonality of modes won't be preserved, and then I will get complex modes of vibration. This step I can't do, the magnitude of the damper I want to add is 1 KNs.M-1 |
|
|
|
|
 |
| Tags |
| complex modes, damping, modal properties |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys Installation on Docker Container | mohsen.shiea | ANSYS | 11 | March 14, 2024 12:18 |
| Ansys CFX 18.1 looking for modelling methane steam reforming | Goenitz | CFD Freelancers | 0 | September 26, 2019 12:44 |
| A CFX-POST error (ver 14.5.7) | wangyflp88 | CFX | 2 | July 22, 2017 01:17 |
| [Workbench] Ansys Bridge Modelling | Dahabreh | ANSYS Meshing & Geometry | 0 | September 25, 2015 09:18 |
| modelling and simulation help needed in Ansys Fluent-willing to pay | engineer.iman | CFD Freelancers | 4 | January 19, 2014 09:05 |
Linear Mode
