 |
 |
 |
|
|
|
[Sponsors] | ||||
August 1, 2016, 09:49
|
How to create a rigid component mesh
|
#1 |
|
New Member
Ranganath
Join Date: Aug 2016
Location: Leuven, Belgium
Posts: 1
Rep Power: 0   |
Hi All,
I wish to create a right component for the hertz contact analysis at Ansys Workbench 17.0. Kindly help me. |
|
|
|
|
|
August 23, 2016, 18:59
|
|
#2 |
|
Senior Member
Charles
Join Date: Aug 2016
Location: Vancouver, Canada
Posts: 151
Rep Power: 10 |
If it is rigid component, it doesn't need mesh (except the contact surface). Component that needs mesh is the one that can deform and thus produce strain/stress. Rigid component does not deform and has any stress.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| Difficulty in calculating angular velocity of Savonius turbine simulation | alfaruk | CFX | 14 | March 17, 2017 07:08 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 08:06 |
Linear Mode
