|
[Sponsors] |
Save a specific data type for a group of nodes |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Nikini Gamage
Join Date: Aug 2014
Posts: 7
Rep Power: 12 ![]() |
Hi Everybody,
I want to modify the fields that Mechanical is outputting at each time step. Rather than writing stress, strain, nodal forces etc over all nodes in the solution matrix, I want to only write out values of selected variables over a specified group of nodes. I essentially want to create my own limited output field. This way I am not writing out data that I don't plan to use, and hopefully, this will speed up my write time at each step and save on file space. I feel like this should be possible, and any help in this matter would be greatly appreciated. Cheers, Nikini PhD Student Auckland Bioengineering Institute The University of Auckland Phone: +64 9 3737599 ext 83499 |
|
![]() |
![]() |
![]() |
Tags |
save data |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
time step continuity problem in VAWT simulation | lpz_michele | OpenFOAM Running, Solving & CFD | 5 | February 22, 2018 19:50 |
Compression stoke is giving higher pressure than calculated | nickjuana | CFX | 62 | May 19, 2015 13:32 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |