Error while coupling between pipe interface

devesh.baghel · March 10, 2011, 07:45

Hi All,

I am trying to make a couple between two pipes. while making couple at the interface of both the pipe, it is throughing error saying that - "ERROR - SLAVE CELL 506 FACE 6 OF COUPLE 361 IS A MASTER IN COUPLE 576".

please help.....if some one having any idea about this problem
thanks alot in advance

Pauli · March 10, 2011, 12:44

You need to delete cell 506 from either couple 361 or couple 576. It can not belong to both.

cpcre,shell is a more robust way to create couples. It takes a little more effort. But usually produces good results - especially with difficult situations like curved surfaces.

devesh.baghel · March 11, 2011, 04:55

Thanks Pauli.....i will try this option....

March 10, 2011, 07:45	Error while coupling between pipe interface	#1
devesh.baghel Member Devesh Baghel Join Date: Mar 2009 Posts: 84 Rep Power: 17	Hi All, I am trying to make a couple between two pipes. while making couple at the interface of both the pipe, it is throughing error saying that - "ERROR - SLAVE CELL 506 FACE 6 OF COUPLE 361 IS A MASTER IN COUPLE 576". please help.....if some one having any idea about this problem thanks alot in advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11

March 10, 2011, 12:44		#2
Pauli Senior Member Pauli Join Date: Mar 2009 Posts: 189 Rep Power: 17	You need to delete cell 506 from either couple 361 or couple 576. It can not belong to both. cpcre,shell is a more robust way to create couples. It takes a little more effort. But usually produces good results - especially with difficult situations like curved surfaces.

March 11, 2011, 04:55		#3
devesh.baghel Member Devesh Baghel Join Date: Mar 2009 Posts: 84 Rep Power: 17	Thanks Pauli.....i will try this option....