unable to see the boundaries in the STAR CD

smkhan · September 29, 2009, 03:39

Hello!

I have a mesh in the Gridgen and also located the bondaries there in the Gridgen. Then ,it is exported from the Gridgen in the PATRAN format and imported it into the STAR CD in the same format. mesh are shown but the boundaries are not able to be seen. then it is exported from STAR CD in the ICEM format and imported into the STAR CCM+ even there mesh is shown as a whole region and the boundaries are not shown.

Thanks

TMG · September 29, 2009, 20:38

try typing
bset, all
bdisplay, on
cplot
If they are there you will see them.

September 29, 2009, 03:39	unable to see the boundaries in the STAR CD	#1
smkhan New Member S M Khan Join Date: Sep 2009 Posts: 17 Rep Power: 17	Hello! I have a mesh in the Gridgen and also located the bondaries there in the Gridgen. Then ,it is exported from the Gridgen in the PATRAN format and imported it into the STAR CD in the same format. mesh are shown but the boundaries are not able to be seen. then it is exported from STAR CD in the ICEM format and imported into the STAR CCM+ even there mesh is shown as a whole region and the boundaries are not shown. Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA,	cfdproject	OpenFOAM Meshing & Mesh Conversion	0	April 14, 2009 16:45
ANSA mesh in star 4	alex	Siemens	6	December 3, 2008 18:30
error in star ccm	maurizio	Siemens	3	October 16, 2007 06:17
periodic boundaries - flow through a net	PK	FLUENT	0	July 12, 2007 12:58
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

September 29, 2009, 20:38		#2
TMG Member Join Date: Mar 2009 Posts: 44 Rep Power: 17	try typing bset, all bdisplay, on cplot If they are there you will see them.