 |
 |
 |
|
|
|
[Sponsors] | ||||
September 24, 2013, 23:20
|
Problem in Spray and Combustion simulation
|
#1 |
|
New Member
John Wang
Join Date: May 2013
Posts: 5
Rep Power: 13  |
Hi,
I am currently performing some simulations of GDI combustion. But I met problems when apply both spray model (Reitz and MIP2) and ECFM-3Z combustion model. The simulations were stopped because of either negative density or the divergence. Trimming method is adopted to get the mesh. I would like to know the reason for the failure of the simulations. Could anyone help me about this? Thanks. Best regards, John |
|
|
|
|
|
October 29, 2013, 06:07
|
|
#2 | |
|
Member
zheng jianjun
Join Date: Jan 2010
Posts: 46
Rep Power: 16 |
check the Courant number,if it is too large, plz decrease the timestep and try again.
Quote:
|
||
|
|
|
||
|
November 8, 2013, 11:11
|
|
#3 | |
|
New Member
John Wang
Join Date: May 2013
Posts: 5
Rep Power: 13 |
It seems reducing the timstep could not solve this problems.
Thank you all the same. Quote:
|
||
|
|
|
||
 |
| Tags |
| spray combustion |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| combustion flow simulation in liquid rocket thrust chamber | geetha sri | FLUENT | 1 | February 4, 2016 18:04 |
| Problem w/ liquid spray combustion(no reaction) | faudiS8 | FLUENT | 1 | June 7, 2012 14:20 |
| combustion simulation | geetha sri | FLUENT | 0 | August 26, 2010 13:56 |
| Simulate spray without Combustion | flying | OpenFOAM Running, Solving & CFD | 7 | June 11, 2010 20:34 |
| diesel engine spray and combustion | usker | Siemens | 6 | April 24, 2006 23:36 |
Linear Mode
