Mesh with repeated volumes

Mlynam · June 10, 2010, 21:31

I am meshing a unit cell of a system in order to reduce the complexity of the overall system. Being a unit cell, it has certain repeated structures in the geometry. The issue I am having is that when I create the mesh in STAR-CCM+ (the geometry is modeled in solidworks) it will create one instance of each structure thereby leaving out any copies. Is this behavior normal? and will it affect my results? Thanks in advance.

ML

Mlynam · June 14, 2010, 14:31

by the way if anyone else had this issue the problem has been solved. changed from "largest internal" volume specification per region to "seed point" then placed seed points in the respective volumes.

RobertB · June 15, 2010, 09:03

Why don't you use the surface remesher on the parasolid instead of the surface wrapper?

From my experience SolidWorks gives surfaces and CCM+ handles them well.

abdul099 · July 6, 2010, 13:24

After using the surface wrapper, i would use the surface remesher anyway....

Mlynam, i'm not sure if i understand it the right way, but check the in-place interfaces if they can help you.

Best regards

June 10, 2010, 21:31	Mesh with repeated volumes	#1
Mlynam New Member Matt Lynam Join Date: Jun 2010 Posts: 8 Rep Power: 16	I am meshing a unit cell of a system in order to reduce the complexity of the overall system. Being a unit cell, it has certain repeated structures in the geometry. The issue I am having is that when I create the mesh in STAR-CCM+ (the geometry is modeled in solidworks) it will create one instance of each structure thereby leaving out any copies. Is this behavior normal? and will it affect my results? Thanks in advance. ML

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 09:54
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM	kawamatt2	ANSYS Meshing & Geometry	17	December 20, 2011 12:45
"Unit" the mesh of two volumes	meshinggod	ANSYS Meshing & Geometry	6	November 10, 2009 06:43
mesh of more than one volumes in icem cfd	ravi	CFX	0	February 4, 2006 11:24

June 14, 2010, 14:31		#2
Mlynam New Member Matt Lynam Join Date: Jun 2010 Posts: 8 Rep Power: 16	by the way if anyone else had this issue the problem has been solved. changed from "largest internal" volume specification per region to "seed point" then placed seed points in the respective volumes.

June 15, 2010, 09:03		#3
RobertB Senior Member Robert Join Date: Jun 2010 Posts: 117 Rep Power: 17	Why don't you use the surface remesher on the parasolid instead of the surface wrapper? From my experience SolidWorks gives surfaces and CCM+ handles them well.

July 6, 2010, 13:24		#4
abdul099 Senior Member Join Date: Oct 2009 Location: Germany Posts: 636 Rep Power: 22	After using the surface wrapper, i would use the surface remesher anyway.... Mlynam, i'm not sure if i understand it the right way, but check the in-place interfaces if they can help you. Best regards