Problem running parallel.

Hernán · December 21, 2009, 10:56

Hello, good afternoon,

We have a problem with a pc we have purchased last week; we want to run a simulation
in parallel mode but a message error appears (enclosed txt). The pc has 8 cores and the
operating system is windows7; we have installated mpich for win 64 at this computer, is
it ok? We think the problem is at the mpi driver or something simmilar, highlight that on
serial mode the simulation works well.

Thank´s for tour attention.

We remain at your disposition for any doubt.

Best regards,

TMG · December 23, 2009, 13:04

The key warning is that it cannot find the MPI distribution. My guess is that you don't have the path to the mpi executables set in your path. It looks to me that mpich was either not installed properly or perhaps not installed for use by all users?

December 23, 2009, 13:04	Parallel	#2
TMG Member Join Date: Mar 2009 Posts: 44 Rep Power: 17	The key warning is that it cannot find the MPI distribution. My guess is that you don't have the path to the mpi executables set in your path. It looks to me that mpich was either not installed properly or perhaps not installed for use by all users?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem using property udfs in parallel mode	EllenW	FLUENT	0	June 23, 2009 18:18
problem loading UDF in parallel fluent	Tim	FLUENT	12	July 12, 2008 13:59
parallel UDF problem	kerem	FLUENT	2	June 20, 2006 07:56
PVM RSH parallel setup problem Windows XP	abe	CFX	11	January 30, 2006 06:10
parallel mode - small problem?	co2	FLUENT	2	June 2, 2004 00:47