|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Fabian
Join Date: Apr 2023
Posts: 5
Rep Power: 3 ![]() |
Hello everybody,
I am working on overset meshes. This might be a very simple question but I didn't find an answer yet. The simulation includes an object that directly touches a wall. Therefore I am using the zero gap interface. I have the problem that at a certain time a whole is cut in the middle of the wall and the object. What might be the issue here? I have added a picture of the time step before the hole is cut and when it is cut. It is a 3d simulation and the picture shows a sectional cut with yellow being the overset mesh and blue the background. Thanks for any help ![]() |
|
![]() |
![]() |
![]() |
Tags |
hole cutting, overset mesh, zero gap |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hole cutting problem using overset of OF1812 | SGWANG | OpenFOAM Running, Solving & CFD | 18 | April 26, 2023 03:52 |
[snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 14:41 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ANSYS Meshing] 3D rotating wind turbine using overset mesh | Paku | ANSYS Meshing & Geometry | 0 | September 10, 2019 23:18 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |