 |
 |
 |
|
|
|
[Sponsors] | ||||
Failed to initialize the solution due to floating point error .How can I rectify this |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 26, 2022, 14:30
|
Failed to initialize the solution due to floating point error .How can I rectify this
|
#1 |
|
New Member
Kerala
Join Date: May 2022
Posts: 7
Rep Power: 4  |
I am trying to do a conjugate heat transfer problem of an engine.But whenever I am trying to initialise the problem floting point error is happening as well as it is showing as AMG coarsening halted. How can I rectify this? I am using STAR CCM+.I had already ran the mesh diagnosis , it seems fine.
|
|
|
|
|
|
| Tags |
| star ccm+, star ccm+ error, star ccm+ help |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2way FSi, Initialize with steady solution, Fluent, Transient Sturcural, System Coupli | mmkkeshavarzi | FLUENT | 1 | June 28, 2024 08:03 |
| [swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 04:30 |
| [OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0 | tlcoons | OpenFOAM Installation | 13 | April 20, 2016 18:34 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| [OpenFOAM] ParaView/Parafoam error when making animation | Disco_Caine | ParaView | 6 | September 28, 2010 10:54 |
Linear Mode
