 |
 |
 |
|
|
|
[Sponsors] | ||||
February 18, 2022, 09:26
|
Meshing near edges
|
#1 |
|
New Member
Raj Dasari
Join Date: Feb 2022
Posts: 13
Rep Power: 4  |
Hello everyone
I'm new to Star ccm+ software. I was trying to do meshing for a simple geometry and the edges of the geometry in not meshed properly. I have attached the pictures of the meshing. Please suggest me to solve this problem. |
|
|
|
|
|
February 19, 2022, 10:35
|
|
#2 |
|
Senior Member
Chaotic Water
Join Date: Jul 2012
Location: Elgrin Fau
Posts: 437
Rep Power: 18 |
Please suggest how the edges of the geometry should be meshed properly.
|
|
|
|
|
|
|
February 21, 2022, 07:56
|
|
#3 |
|
New Member
Raj Dasari
Join Date: Feb 2022
Posts: 13
Rep Power: 4 |
It is a cylindrical geometry with two different diameters. After meshing the smaller Diameter circular edge is completely deformed.
|
|
|
|
|
|
|
February 21, 2022, 15:06
|
|
#4 |
|
New Member
Hollis Williams
Join Date: Jan 2022
Posts: 16
Rep Power: 4 |
I'm not an expert but that mesh looks quite coarse, what happens if you try a finer mesh?
Just clear meshes, change the parameters, then run everything again with a finer mesh. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Meshing sharp edges | kandelabr | OpenFOAM Meshing & Mesh Conversion | 1 | August 25, 2017 10:02 |
| [ANSYS Meshing] Smoothening ofSharp Edges for easy Meshing | Saksham Bhutani | ANSYS Meshing & Geometry | 2 | November 28, 2015 07:56 |
| [ANSYS Meshing] How to not consider all edges during meshing | RodriguezFatz | ANSYS Meshing & Geometry | 19 | November 26, 2015 08:39 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| Boundary layer meshing with sharp trailing edges | Andrew Berner | FLUENT | 1 | August 28, 2007 18:39 |
Linear Mode
