Gradually increase cell sizes

oysteinb · April 19, 2021, 06:38

Hi!

I have a question regarding volume mesh controls. I have a volume mesh of a model of about 150 buldings in Oslo with quite a large domain. (See Picture 1) What I want to know is how this can be changed to have smaller cell sizes towards the bottom, and larger towards the top (meaning it should be almost the same number of cell sizes). I've added an example of how I want the mesh to be (see Picture 2). Is there a way to control this?

I hope the question was clear, if not, let me know and I will explain further.

Regards
Øystein

fluid23 · April 19, 2021, 14:45

I think you answered your own question. A series of volumetric controls.

In reality, it is a combination of that and other mesher settings, including your surface mesh to an extent.

Have you tried creating a volumetric control?

cwl · April 20, 2021, 07:24

Field Function Refinement Table (in Operations -> Automated Mesh -> Surface Remesher, Polyhedral Mesher) set to the Table containing data extracted from user set Field Function that depends on z-coordinate ($$Position[2]) could help, but i'm not sure - how it will work with Surface and Volumetric Controls/

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Error when setting locationsInMesh	elonesampaio	OpenFOAM Meshing & Mesh Conversion	1	April 3, 2021 18:44
Cell Reynolds Number	laliong	Main CFD Forum	12	September 17, 2019 04:18
How to use "translation" in solidBodyMotionFunction in OpenFOAM	rupesh_w	OpenFOAM Running, Solving & CFD	5	August 16, 2016 05:27
interFoam running blowing up	sandy13	OpenFOAM Running, Solving & CFD	2	May 5, 2015 08:16
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case	sharonyue	OpenFOAM Meshing & Mesh Conversion	1	April 23, 2013 00:34

April 19, 2021, 14:45		#2
fluid23 Senior Member Matt Join Date: Aug 2014 Posts: 947 Rep Power: 18	I think you answered your own question. A series of volumetric controls. In reality, it is a combination of that and other mesher settings, including your surface mesh to an extent. Have you tried creating a volumetric control?

April 20, 2021, 07:24		#3
cwl Senior Member Chaotic Water Join Date: Jul 2012 Location: Elgrin Fau Posts: 437 Rep Power: 18	Field Function Refinement Table (in Operations -> Automated Mesh -> Surface Remesher, Polyhedral Mesher) set to the Table containing data extracted from user set Field Function that depends on z-coordinate ($$Position[2]) could help, but i'm not sure - how it will work with Surface and Volumetric Controls/