Unable to read csv

timowerder · November 13, 2020, 03:42

Hi everyone,

I know that this question was already asked a few times but none of the usual answers could help me.

I am trying to import a csv to get a 2D Spline and it states something like "Unable to read inout and .csv..."

What is not wrong:
I tried the diffrent CSV formats (MS DOS, etc.).
In my excel sheet the numbers are not in the same column.
I have a z-Coordinate which is zero in column C.

Could there be anything wrong with star ccm+ or is ther a diffrent way to get my spline into star ccm?

Thanks

ping · November 25, 2020, 17:17

i doubt there is a problem with the code.
i'd be getting a proper text editor like notepad++ then as a test paste in the sample numbers in the help page
Pre-Processing > Modeling Geometry > Using 3D-CAD > Importing Geometry into 3D-CAD > Using 2D and 3D Curves in 3D-CAD > File Format for Imported Curves
and import that.
if that works then open your file in notepad++ and look for problems in format, hidden characters etc

November 13, 2020, 03:42	Unable to read csv	#1
timowerder New Member Timo Kaiser Join Date: Nov 2020 Posts: 2 Rep Power: 0	Hi everyone, I know that this question was already asked a few times but none of the usual answers could help me. I am trying to import a csv to get a 2D Spline and it states something like "Unable to read inout and .csv..." What is not wrong: I tried the diffrent CSV formats (MS DOS, etc.). In my excel sheet the numbers are not in the same column. I have a z-Coordinate which is zero in column C. Could there be anything wrong with star ccm+ or is ther a diffrent way to get my spline into star ccm? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent Parallelization Problem After AC Power Dropped	pawl	Hardware	5	November 13, 2016 07:08
How to make a code parallel?	Bruno Machado	Fluent UDF and Scheme Programming	15	May 27, 2016 10:18
How to setup a simple OpenFOAM cluster?	TommiPLaiho	OpenFOAM Installation	3	October 27, 2013 16:15
OpenFOAM 1.6.x - CentOS 5.3 x86_64	linnemann	OpenFOAM Installation	68	April 22, 2013 12:03
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 18:51

November 25, 2020, 17:17		#2
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	i doubt there is a problem with the code. i'd be getting a proper text editor like notepad++ then as a test paste in the sample numbers in the help page Pre-Processing > Modeling Geometry > Using 3D-CAD > Importing Geometry into 3D-CAD > Using 2D and 3D Curves in 3D-CAD > File Format for Imported Curves and import that. if that works then open your file in notepad++ and look for problems in format, hidden characters etc