Total pressure coefficient

lauren_f1 · August 8, 2019, 13:48

I have simulated a the flow around a car at 20m/s and the total pressure coefficient does not reach 1 in the freestream area. Usually you see mostly red in freestream so I think I must have a setting thats incorrect but I'm unsure what it could be. Instead of being 1 its around 0.4 or 0.5.
Any help would be greatly appreciated!

me3840 · August 9, 2019, 00:04

Did you set the total pressure coefficient reference parameters correctly?

spdesai · November 25, 2021, 09:20

It could be several things:
1) You might be computing the total pressure coefficient incorrectly (check to make sure your reference static and dynamic pressures are correct).
2) Did you confirm that your computation is converged properly after conducting a grid refinement study?
3) Is your CFD input correct (for eg. the free stream velocity? Are you ensuring you're using the right solver etc.?)

August 8, 2019, 13:48	Total pressure coefficient	#1
lauren_f1 New Member Lauren Join Date: Aug 2019 Posts: 1 Rep Power: 0	I have simulated a the flow around a car at 20m/s and the total pressure coefficient does not reach 1 in the freestream area. Usually you see mostly red in freestream so I think I must have a setting thats incorrect but I'm unsure what it could be. Instead of being 1 its around 0.4 or 0.5. Any help would be greatly appreciated!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Getting divergence while increasing the back pressure at pressure outlet	greenfields15	FLUENT	0	March 19, 2018 00:39
Negative Total Pressure Loss Coefficient near the casing in axial compressor	mitra22	CFX	1	December 15, 2017 23:34
Simple piston movement in cylinder- fluid models	arun1994	CFX	4	July 8, 2016 03:54
Star cd es-ice solver error	ernarasimman	STAR-CD	2	September 12, 2014 01:01
Pressure Inlet: question about total pressure	I-mech	FLUENT	0	July 13, 2014 06:38

August 9, 2019, 00:04		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 25	Did you set the total pressure coefficient reference parameters correctly?

November 25, 2021, 09:20		#3
spdesai New Member Join Date: Jul 2019 Posts: 2 Rep Power: 0	It could be several things: 1) You might be computing the total pressure coefficient incorrectly (check to make sure your reference static and dynamic pressures are correct). 2) Did you confirm that your computation is converged properly after conducting a grid refinement study? 3) Is your CFD input correct (for eg. the free stream velocity? Are you ensuring you're using the right solver etc.?)