Cross section pipe with DEM particles

jeroendemto · December 4, 2018, 09:30

Hello everyone!

I'd like to make a cross section of a pipe with DEM particles. I want to show where the particles are located in this pipe. My idea was to make a small volume and only show the particles in this volume. But I can't figure out how this can be done. If you know where I can find more information or how to do this, please tell me.

Kind regards,
Jeroen

jeroendemto · December 7, 2018, 08:29

I found a solution, you can make a threshold as a derived part and use this to make a cross section.

December 4, 2018, 09:30	Cross section pipe with DEM particles	#1
jeroendemto New Member Join Date: Sep 2018 Posts: 25 Rep Power: 8	Hello everyone! I'd like to make a cross section of a pipe with DEM particles. I want to show where the particles are located in this pipe. My idea was to make a small volume and only show the particles in this volume. But I can't figure out how this can be done. If you know where I can find more information or how to do this, please tell me. Kind regards, Jeroen

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cell average on cross section plane	David_010	OpenFOAM Running, Solving & CFD	1	June 10, 2016 12:35
[Other] How to create an MRF zone ?	aminem	OpenFOAM Meshing & Mesh Conversion	2	December 8, 2014 11:45
cross section average	Paul	FLUENT	0	April 12, 2006 12:30
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 22:31

December 7, 2018, 08:29		#2
jeroendemto New Member Join Date: Sep 2018 Posts: 25 Rep Power: 8	I found a solution, you can make a threshold as a derived part and use this to make a cross section.