Sewing body Cause Duplicate Faces

KindaHungry · August 17, 2018, 12:40

Good Day everybody!

I have a problem of duplicate faces when I do CAD in StarCCM. I was trying to sew three sheet bodies together. After sewing it becomes a body and i checked the validity, the system show "All selected body are valid", however when i test meshing on that sewed-body, it gives error of duplicate face.

Anyone had this problem and have a solution to resolve this? or Any suggestion?

SoAero · August 21, 2018, 08:13

Can you post a picture of the geometry in the problem area?

KindaHungry · September 12, 2018, 07:47

This is the picture of the problem

SoAero · September 12, 2018, 10:17

That's a picture of the geometry, not the bad mesh. Go into surface repair and show the diagnostics and the problem areas please.

August 17, 2018, 12:40	Sewing body Cause Duplicate Faces	#1
KindaHungry New Member Join Date: Jun 2018 Location: Malaysia Posts: 16 Rep Power: 8	Good Day everybody! I have a problem of duplicate faces when I do CAD in StarCCM. I was trying to sew three sheet bodies together. After sewing it becomes a body and i checked the validity, the system show "All selected body are valid", however when i test meshing on that sewed-body, it gives error of duplicate face. Anyone had this problem and have a solution to resolve this? or Any suggestion?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	92	May 21, 2024 08:56
GenerateVolumeMesh Error - Surface Wrapper Self Interacting (?)	AndreP	STAR-CCM+	10	August 2, 2018 08:48
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library	aylalisa	OpenFOAM Installation	23	June 15, 2015 15:49
createPatch Segmentation Fault (CORE DUMPED)	sam.ho	OpenFOAM Pre-Processing	2	April 21, 2014 03:01
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 11:52

August 21, 2018, 08:13		#2
SoAero New Member Owen Join Date: Aug 2018 Posts: 20 Rep Power: 8	Can you post a picture of the geometry in the problem area?

September 12, 2018, 10:17		#4
SoAero New Member Owen Join Date: Aug 2018 Posts: 20 Rep Power: 8	That's a picture of the geometry, not the bad mesh. Go into surface repair and show the diagnostics and the problem areas please.