Error during surface wrapping

Thomas2009 · October 3, 2017, 21:38

Hello Everyone,

I´m going to make a fullmodel simulation of a racecar using StarCCM+.
The problem is that I already have a halfcut model simulation which works quite well. Now I was trying to make a fullmodel version and the following error occured:

surface wrapper cannot be applied simultaneously at multiple regions

This error occures every single time I´m going to mesh the model and right after the surface wrapper is completed.
Has anybody ever had this type of error? I know that the troubleshooting and especially the error report is not quite well in StarCCM.

I would be grateful if anybody could help me with my problem.

greetings

Thomas2009

hanif · December 12, 2017, 01:53

You need to split into two different mesh for two different region. That will usually help.

Kotabhi · August 8, 2019, 15:19

Hi,

I am working on a simple curved surface and I am receiving the same error when I am trying to mesh the surface. I have uploaded the file. I have been receiving the same error with other simulations, it's a bit frustrating.

Please have a look and let me know how I can solve this. Thank you.

October 3, 2017, 21:38	Error during surface wrapping	#1
Thomas2009 New Member Thomas Amhofer Join Date: Oct 2017 Posts: 2 Rep Power: 0	Hello Everyone, I´m going to make a fullmodel simulation of a racecar using StarCCM+. The problem is that I already have a halfcut model simulation which works quite well. Now I was trying to make a fullmodel version and the following error occured: surface wrapper cannot be applied simultaneously at multiple regions This error occures every single time I´m going to mesh the model and right after the surface wrapper is completed. Has anybody ever had this type of error? I know that the troubleshooting and especially the error report is not quite well in StarCCM. I would be grateful if anybody could help me with my problem. greetings Thomas2009

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
Simulation of varying contact angles for a large droplet of water on a surface	cp703	CFX	5	July 20, 2013 07:08
[snappyHexMesh] Add additional boundary layers to complex stl surface	tobijingles	OpenFOAM Meshing & Mesh Conversion	1	October 26, 2011 11:45
Patran Volume Meshing	Deb	CFX	19	April 17, 2003 11:56
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 07:47

December 12, 2017, 01:53		#2
hanif New Member hanif Join Date: Nov 2017 Posts: 2 Rep Power: 0	You need to split into two different mesh for two different region. That will usually help.