Issue running simulation on CAD model

Jagjourdan · February 14, 2017, 13:24

Hi all,

I'm a final year student studying aerospace engineering and for my project I need to run a simulation on fluid flow on a model I have created in Catia.

The video I was using as a tutorial for this can be seen below:

https://www.youtube.com/watch?v=9MYVeklXDh4

I've been able to follow every step of the video in terms of using a box to simulate a wind tunnel however I seem to have a problem towards the end of the video where a scalar function is selected. I have started over again several times and I never seem to be able to get velocity and pressure as one of the functions to use to obtain values on for the report of my results.

If anyone could help me it would be greatly appreciated.

me3840 · February 22, 2017, 19:43

If pressure and velocity are not available as functions then your physics selection is incomplete. Look at your physics continua.

February 14, 2017, 13:24	Issue running simulation on CAD model	#1
Jagjourdan New Member Jourdan Join Date: Feb 2017 Posts: 1 Rep Power: 0	Hi all, I'm a final year student studying aerospace engineering and for my project I need to run a simulation on fluid flow on a model I have created in Catia. The video I was using as a tutorial for this can be seen below: https://www.youtube.com/watch?v=9MYVeklXDh4 I've been able to follow every step of the video in terms of using a box to simulate a wind tunnel however I seem to have a problem towards the end of the video where a scalar function is selected. I have started over again several times and I never seem to be able to get velocity and pressure as one of the functions to use to obtain values on for the report of my results. If anyone could help me it would be greatly appreciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simulation of Axisymmetric Free Jet using LRR Reynolds Stress Model	skyinventorbt	OpenFOAM	1	January 2, 2022 18:42
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 07:20
[DesignModeler] CAD model of a dropping/filling process	rob3	ANSYS Meshing & Geometry	0	July 23, 2014 00:52
Statically Compiling OpenFOAM Issues	herzfeldd	OpenFOAM Installation	21	January 6, 2009 10:38
Kubuntu uses dash breaks All scripts in tutorials	platopus	OpenFOAM Bugs	8	April 15, 2008 08:52

February 22, 2017, 19:43		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 25	If pressure and velocity are not available as functions then your physics selection is incomplete. Look at your physics continua.