|
[Sponsors] |
October 4, 2016, 05:06 |
pressure decrease
|
#1 |
New Member
Haiqin
Join Date: Jun 2016
Posts: 15
Rep Power: 10 |
I work with Eulerian multiphase model to simulate gas-solid fluidized bed in 2D with StarCMM+, and have set the inlet as 'velocity inlet', the outlet as 'pressure outlet', and physical time as '20s'. I have created a 'sum report' for pressure at bottom (derived part: line probe, y=0), and used this report to create a monitor. I have observed that the pressure decreased as the simulation proceeded. When the simulation finished (physical time=20s), the pressure was only around 30% of the initial value.
Do anybody have any idea about this? It is not logical, right? |
|
Tags |
pressure decrease |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How do I specify a decrease in pressure? | Somebody | CFX | 19 | May 21, 2022 06:11 |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
Periodic flow using Cyclic - comparison with Fluent | nusivares | OpenFOAM Running, Solving & CFD | 30 | December 12, 2017 05:35 |
Outlet pressure | aja1345 | FLUENT | 5 | August 18, 2015 11:02 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |