 |
 |
 |
|
|
|
[Sponsors] | ||||
May 15, 2015, 13:26
|
Boundary conditions
|
#1 |
|
New Member
Nithish
Join Date: Sep 2013
Location: Erlangen,Germany
Posts: 20
Rep Power: 13  |
Hello All,
I am trying to simulate flow inside cylinder. Iam confused with boundary conditions I would like to know if the flow is stable by applying pressure boundary and velocity conditions at inlet and outlet and what should give for the wall. using incompressible steady state solver. |
|
|
|
|
|
May 17, 2015, 15:21
|
|
#2 |
|
New Member
Join Date: Feb 2015
Posts: 26
Rep Power: 11 |
mass flow inlet is good and you can use outlet flow for outlet
|
|
|
|
|
|
|
May 18, 2015, 00:54
|
|
#3 |
|
Senior Member
Lane Carasik
Join Date: Aug 2014
Posts: 692
Rep Power: 15 |
Do you have any more details than "flow inside a cylinder?"
|
|
|
|
|
|
 |
| Tags |
| cfd analysis, starccm+, turbulence analysis |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 10:49 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| [Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 10:38 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
