Error Message when initialising BodyHandle:no Body defined!

alistair.galbraith · March 8, 2015, 21:51

Hi,

After I set up the simulation following the Overset mesh and the DFBI:Boat in Head waves, I attempted to initiate the simulation however I came across the error message

An internal error has occurred. Please contact your support representative with details. BodyHandle:no Body defined!

These messages also appeared down the bottom,

Error: Server Error
Expression:-body
File:BodyHandle.cpp

What does this message mean and how can I sort it?

Kind Regards,

Alistair

fluid23 · March 9, 2015, 09:53

It will likely be difficult for the average user on this forum to intepret these error messages. It's probably something trivial in your setup and the support representative will be able to help you quickly and easily.

Log into the steve portal and create a case, it should say who your DSE is and they will contact you if you after the case is submitted.

March 8, 2015, 21:51	Error Message when initialising BodyHandle:no Body defined!	#1
alistair.galbraith New Member Alistair Galbraith Join Date: Mar 2015 Location: Glasgow Posts: 4 Rep Power: 11	Hi, After I set up the simulation following the Overset mesh and the DFBI:Boat in Head waves, I attempted to initiate the simulation however I came across the error message An internal error has occurred. Please contact your support representative with details. BodyHandle:no Body defined! These messages also appeared down the bottom, Error: Server Error Expression:-body File:BodyHandle.cpp What does this message mean and how can I sort it? Kind Regards, Alistair

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] How can I define different zones in ICEM?	llrr	ANSYS Meshing & Geometry	14	February 12, 2017 14:44
Drawing 3d body and immersed boundary method (IBM)	quarkz	Main CFD Forum	0	December 16, 2011 18:59
Rigid Body mesh deforms	erkileitaru	FLUENT	0	November 20, 2011 13:28
OpenFOAM static build on Cray XT5	asaijo	OpenFOAM Installation	9	April 6, 2011 13:21
OpenFOAM13 for Mac OSX Darwin 104	hjasak	OpenFOAM Installation	70	September 24, 2010 06:06

March 9, 2015, 09:53		#2
fluid23 Senior Member Matt Join Date: Aug 2014 Posts: 947 Rep Power: 18	It will likely be difficult for the average user on this forum to intepret these error messages. It's probably something trivial in your setup and the support representative will be able to help you quickly and easily. Log into the steve portal and create a case, it should say who your DSE is and they will contact you if you after the case is submitted.