Working with tables

skapetan · December 8, 2014, 08:10

Hi,

I want to get the Heat Transfer Coefficient and the Nusselt Number at some specific points in my simulation. I'm trying to create a XYZ internal table and select the related parts, but without getting the results at my coordinates of interest.

Is it possible to specify the x-coordinates in the table?

I tried to create a Point in Derived parts and to select this point as an part in my XYZ internal table but without getting any results.

Thank you.

me3840 · February 9, 2015, 02:11

You don't need a table for this, just make a point probe for each point and make a report of your desired function on that point.

December 8, 2014, 08:10	Working with tables	#1
skapetan New Member Join Date: Apr 2014 Posts: 24 Rep Power: 12	Hi, I want to get the Heat Transfer Coefficient and the Nusselt Number at some specific points in my simulation. I'm trying to create a XYZ internal table and select the related parts, but without getting the results at my coordinates of interest. Is it possible to specify the x-coordinates in the table? I tried to create a Point in Derived parts and to select this point as an part in my XYZ internal table but without getting any results. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is the subsetMotionSolver working in parallel?	Arnoldinho	OpenFOAM Running, Solving & CFD	7	April 27, 2016 05:38
OpenFoam 1.7.1 in Ubuntu 10.04 won't start working	Leech	OpenFOAM Installation	8	August 10, 2014 21:42
DPM parallel is not working but serial is working	johnwinter	FLUENT	1	March 27, 2012 03:01
Working directory	mgonzalo	FLUENT	1	November 11, 2011 11:05
viewing cfx post while working on cfx solver manager	HMR	CFX	5	March 9, 2011 23:33

February 9, 2015, 02:11		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 25	You don't need a table for this, just make a point probe for each point and make a report of your desired function on that point.