|
[Sponsors] |
March 12, 2014, 04:12 |
tutorial
|
#1 |
Senior Member
christine
Join Date: Jul 2009
Location: europe
Posts: 125
Rep Power: 17 |
hello everyone
I'm trying to practise meshing with starccm. Is there any problem with the first tutorial (manifoldWrap) : no way to pick up the 4 corner to create a surface (step before run leak detection) or is there something one should be careful when selecting these 4 points? I can only select 2 of them. Tride again and again, but no way...a bug? Thank you for any clue. |
|
March 12, 2014, 11:03 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
You are using the polygonal patch tool in this step, it is not necessary to explicitly select vertices. As long as you click somewhere on the flat face you should be OK.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem on Fluent Tutorial: Horizontal Film Boilig | Feng | FLUENT | 2 | April 13, 2013 05:34 |
[Virtualization] OpenFOAM oriented tutorial on using VMware Player - support thread | wyldckat | OpenFOAM Installation | 2 | July 11, 2012 16:01 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Rotor/stator tutorial, and how to... | gilberto | CFX | 5 | January 21, 2002 09:41 |