|
[Sponsors] |
February 3, 2014, 21:36 |
Coordinate System Help
|
#1 |
New Member
Chad
Join Date: Jul 2012
Posts: 5
Rep Power: 14 |
I am new to Star-ccm+, and I am a little confused about the coordinate system. I am importing the frame of a multi-rotor copter, and I want to place a blade element model at each of the motor ends. However, I am not sure about the placement of each of these coordinates. Is there any way to find the coordinates of certain points on your model?
|
|
February 4, 2014, 01:00 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Check your other post, please don't double post.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
coordinate system poroussimplefoam | tehzap | OpenFOAM Pre-Processing | 0 | November 28, 2013 10:40 |
local coordinate system for porousZone | Nico A. | OpenFOAM Programming & Development | 0 | November 15, 2011 04:32 |
Creating Coordinate System | ashtonJ | CFX | 0 | February 17, 2011 21:07 |
Coordinate System | selim | CFX | 1 | October 26, 2007 21:08 |
Coordinate system | Franch | Siemens | 2 | March 6, 2002 07:56 |