|
[Sponsors] |
October 9, 2013, 05:27 |
1D mesh with StarCCM+
|
#1 |
New Member
Thomas
Join Date: Oct 2013
Posts: 1
Rep Power: 0 |
Hi,
I need some help on how using StarCCM+ to create a 1D mesh to study, at first, a flow in a duct. I have created a 3D part and try to mesh only in the x-axis but the problem is that with trimmer, for example, the other surfaces are meshed too and so the volume mesh is 3D. Thanks for helping. Thomas. |
|
October 12, 2013, 15:11 |
|
#2 |
New Member
Join Date: Mar 2009
Location: Brazil
Posts: 16
Rep Power: 17 |
Hi Thomas,
I'd start with a Trimmer only mesh continua with a given base size. E.g.: 1mm. Then, create a rectangular channel in x-axis, where the cross section at x0 (inlet) and x1 (outlet) are 1mm^2. Thus, if the channel has 100mm it will have 100 points. The other channel faces (y0, y1, z0 and z1) set as symmetry. Now you have a 1D problem being solved with a 3D mesh.
__________________
Cheers, cfdguy ** Every rose has its thorn ** PS: Please watch this Youtube channel. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
[Other] Problems with starccm mesh | AndTen | OpenFOAM Meshing & Mesh Conversion | 1 | February 23, 2010 04:43 |