 |
 |
 |
|
|
|
[Sponsors] | ||||
November 12, 2012, 06:23
|
wave generation in star ccm+
|
#1 |
|
New Member
Anuj Gupta
Join Date: Oct 2012
Posts: 3
Rep Power: 14  |
I am doing a wave structure interaction problem in Starccm+ my problem is that after some iteration my total wave surface is going down (i.e. water level) even i keep the release time of the structure is around 8 sec because i want to see the effect of waves .
My boundary condition is 5 are velocity inlets and one is pressure outlet according to the tutorial. please can any one suggest me something . |
|
|
|
|
|
May 31, 2013, 13:27
|
|
#2 |
|
Member
Arun Krishnan.L.H
Join Date: Jan 2013
Posts: 75
Rep Power: 13 |
Do you still have the problem or did you figure out?
Arun |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 05:04 |
| Problem In Star CCM Plus | ramarya | STAR-CCM+ | 1 | July 10, 2011 06:59 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 05:38 |
| error in star ccm | maurizio | Siemens | 3 | October 16, 2007 06:17 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
