set up the boundary condition by using star ccm+

layth · October 5, 2011, 10:50

hello every one

could any one help me to specify the boundary condition for inlet and outlet flow inside turbocharger compressor by using star ccm+ software

I will very happy and grateful if you reply me

warm regards

Emara · October 8, 2011, 06:49

Can you give some more details?

Have you split the boundaries or not? if you have, the next step is to define the inlet boundary as (Velocity inlet or Stagnation inlet) whatever your design is and the same for the exit boundary whether Pressure outlet or Flow-Split.

layth · October 8, 2011, 08:28

helle sir,

thank you for reply me

I have impeller blade passage for centrifugal compressor i already used the staganation boundary condition for inlet and already used pressure outlet for outlet . what i want to know what is the values for pressure at inlet and outlet.

best regards

manojaero12 · February 12, 2013, 09:34

i need the inlet condition for turbocharger can anyone help me please

October 5, 2011, 10:50	set up the boundary condition by using star ccm+	#1
layth New Member layth Join Date: Apr 2011 Posts: 10 Rep Power: 15	hello every one could any one help me to specify the boundary condition for inlet and outlet flow inside turbocharger compressor by using star ccm+ software I will very happy and grateful if you reply me warm regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mixed inflow/outflow downstream boundary condition question	peob	OpenFOAM Running, Solving & CFD	3	February 3, 2017 11:54
How to set the Heat Flux boundary condition at Outlet	creddy_trddc	CFX	3	September 21, 2011 08:44
vorticity boundary condition	bearcharge	Main CFD Forum	0	May 14, 2010 12:32
how to set up a wall boundary condition according to calculated wall shear stress?	gameoverli	OpenFOAM Pre-Processing	1	May 21, 2009 09:28
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55

October 8, 2011, 06:49		#2
Emara New Member Join Date: Aug 2011 Posts: 14 Rep Power: 15	Can you give some more details? Have you split the boundaries or not? if you have, the next step is to define the inlet boundary as (Velocity inlet or Stagnation inlet) whatever your design is and the same for the exit boundary whether Pressure outlet or Flow-Split.

October 8, 2011, 08:28		#3
layth New Member layth Join Date: Apr 2011 Posts: 10 Rep Power: 15	helle sir, thank you for reply me I have impeller blade passage for centrifugal compressor i already used the staganation boundary condition for inlet and already used pressure outlet for outlet . what i want to know what is the values for pressure at inlet and outlet. best regards

February 12, 2013, 09:34		#4
manojaero12 New Member manoj Join Date: Feb 2013 Posts: 2 Rep Power: 0	i need the inlet condition for turbocharger can anyone help me please