|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
wei
Join Date: Apr 2009
Posts: 17
Rep Power: 17 ![]() |
Do you have any idea how to map a flat surface with tetrahedral cell to a curve surface with hexahedral cell?
There is a small gap between these two surface. What commands should I use? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
Anton Lyaskin
Join Date: Mar 2009
Location: Samara, Russia
Posts: 66
Rep Power: 17 ![]() |
VPROJECT, I suppose. You'll also need to create shells at "target" surface before using it
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
wei
Join Date: Apr 2009
Posts: 17
Rep Power: 17 ![]() |
thank you. i use 'vproj' to project the vertices to the surface. it works.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
curve surface problem | sianG | CFX | 0 | February 8, 2009 08:52 |
Normal - Helical Surface | m. malik | Main CFD Forum | 3 | February 3, 2006 12:56 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |