|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Flavio Zancanaro
Join Date: Apr 2009
Posts: 2
Rep Power: 0 ![]() |
Hi!
I'm doing a simulation of the ASTM CFR engine, using the es-ice software (StarCd version 4.08.020). I cann't achieve to model the inlet valve, because it has a 180 degrees shroud on the valve. Is it possible to model the inlet valve with 180 degrees shroud on the valve? Has this type of modeling already done by anyone? Thank's Regards Flavio Zancanaro |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |
FLOW THROUGH AN ENGINE INLET VALVE | TOM | FLUENT | 0 | November 5, 2001 10:42 |
inlet valve annulus | Lars Wiese | FLUENT | 0 | March 31, 2000 04:31 |
inlet valve meshing and calculation | PLenchette Julien | Main CFD Forum | 1 | March 5, 1999 17:37 |