|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Dear,
I would need the system requirements for star-cd and some pre and post processors. Thank You, Jaro |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
This is strongly depending on the models you want to run and the environment you are working on.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
The model can have around 2 milions cells and it is planned to run on windows xp. 3GB RAM, CPU Quadro and 3Ghz, would be enough to finish the model in a acceptable time (1-2 hours)
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
I would recommend that you increase your memory, because the number of cells depends on memory. I had similar experience before, my memory was also 3GB but I could not run cases with over million cells, although I used Linux.
Regards |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh requirements! | raja | Main CFD Forum | 2 | August 14, 2007 13:43 |
CPU requirements | aPpA | FLUENT | 2 | June 19, 2005 00:24 |
System Requirements | Christoph Gebhardt (Gebhardt) | OpenFOAM Installation | 1 | February 3, 2005 07:30 |
memory requirements | Novak Elliott | CFX | 3 | June 6, 2003 02:50 |
CFD hardware requirements | Jayprakash | Main CFD Forum | 1 | February 1, 2000 18:24 |