|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello!
I faced a critical problem when I used STARDESING. After making geometry and surface meshes, I got the following error message making volume meshes: 1)Error: Tried to execute: /opt/starcd/v3.26/PROSTAR/3.26.003/linux_2.4-x86-glibc_2.3.2/bin/ammbatch 2) System error message: Operation not permitted Error: Subsurface generation failed: please look at the procadmesh.log file in the directory: tmp_stardesign I have no idea of this. Woruld you give me a direction to solve this error? Have a nice day! |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Do as the message says and read the log file(s) - it will usually give you additional information like a self-intersection error.
Try loading the surface file into proam (open the .dbs file) and do a surface check. Then go back to your CAD in STAR-Design and make some changes locally where the problem was located - change the geom, locally refine the mesh size etc. |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
In my case, surface meshes are well generated. The problem is the volume meshes. Are there any "ammbatch" problem and STARDESIGN version problem?
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem on volume mesh | wan | CFX | 0 | January 29, 2008 02:41 |
Help! i need help Mesh volume problem | Sergi | CFX | 1 | February 1, 2006 16:29 |
error during generate mesh in stardesign | xhliu1 | Siemens | 1 | July 29, 2005 08:59 |
Mesh in stardesign to starcd! | xhliu1 | Siemens | 2 | July 6, 2005 23:06 |
transfer mesh in stardesign to starcd | xhliu1 | Siemens | 1 | June 19, 2005 03:35 |