|
[Sponsors] |
September 6, 2007, 04:39 |
mesh generation
|
#1 |
Guest
Posts: n/a
|
I created the rectangular block using the splines but i unable to mesh the block by spcifying the number of cells along x,y,z direction..please tell the proper procedure..
|
|
September 13, 2007, 01:46 |
Re: mesh generation
|
#2 |
Guest
Posts: n/a
|
Use Block mesh generation. Refer manual for more information.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh generation | srikanth | Main CFD Forum | 1 | January 26, 2006 06:02 |
mesh generation | ramesh | Siemens | 6 | October 10, 2005 07:34 |
RE. Mesh Generation Help | Patel Amit R. | FLUENT | 0 | July 12, 2003 03:03 |
mesh generation | Matthias | Main CFD Forum | 0 | February 4, 2002 10:22 |
MESH GENERATION | SANJIB DAS SHARMA | Main CFD Forum | 7 | May 13, 2000 08:16 |