 |
 |
 |
|
|
|
[Sponsors] | ||||
June 29, 2007, 13:14
|
scripting in GridGen
|
#1 |
|
Guest
Posts: n/a
|
Hi, I would like to know if it is possible to use some tools like loop or if-else with TCL in glyph in GridGen? I have to create a paramtic form and I nedd to use these tools, will it work?? or Have I to give-up this idea?
Thanks for your response Tim |
|
|
||
|
June 30, 2007, 14:33
|
Re: scripting in GridGen
|
#2 |
|
Guest
Posts: n/a
|
Tim,
Yes, you can use Tcl's looping, if-then-else, and every other bit of Tcl syntax to write Glyph scripts. Good luck. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| icem- scripting!!!!!!!!!!!!!!!! | ganesh | CFX | 0 | March 10, 2009 05:24 |
| using loops in icem cfd scripting | krishna | CFX | 1 | February 27, 2009 05:42 |
| icem-cfd-scripting problem... | tushar | CFX | 4 | February 20, 2009 02:06 |
| scripting gridgen: why a connector is not saved?? | Tim | Siemens | 2 | July 28, 2007 17:11 |
| [OpenFOAM] ParaFoam Scripting | iyer_arvind | ParaView | 7 | November 2, 2006 05:06 |
Linear Mode
