|
[Sponsors] |
April 22, 2007, 05:09 |
no temperature at monitoring location
|
#1 |
Guest
Posts: n/a
|
I m doing a moving mesh problem and when the iterations crossed 180(360 DCA) every parameters at monitoring locations dips to Zero suddenly except pressure.. Y its so?? its happened at the end of compression sroke n starting point of expansion.. i m doing amovin mesh analysis in diesel engine using STAR CD.. please give a solution.. thank u..
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Maximum temperature at each axial location | Eric | FLUENT | 0 | March 14, 2009 07:30 |
Average Temperature vs. Location, Star-CCM+ | new2CFD | Siemens | 6 | March 13, 2008 15:57 |
What is Monitoring cell? | Tipakorn | Siemens | 2 | March 28, 2006 21:38 |
CPU Monitoring | Bob | FLUENT | 2 | June 2, 2004 19:51 |
monitoring | neil | FLUENT | 1 | March 4, 2003 00:35 |