Macro problem

April 9, 2007, 11:17

Hi

I created a macro in version 3.15, then imported the macro to be used in version 3.26. When I click on 'Execute macro', errors saying that I cannot execute command like getv all. However, if I select all contents of the macro and click on 'Macro Selection', the macro was well executed without any error. Why did this strange thing happened? Is it because of the problem of different version of starCD?

April 9, 2007, 13:37

if you are using windows it might be the problem: windows xp

April 9, 2007, 11:17	Macro problem	#1
cfddummy Guest Posts: n/a	Hi I created a macro in version 3.15, then imported the macro to be used in version 3.26. When I click on 'Execute macro', errors saying that I cannot execute command like getv all. However, if I select all contents of the macro and click on 'Macro Selection', the macro was well executed without any error. Why did this strange thing happened? Is it because of the problem of different version of starCD?

April 9, 2007, 13:37	Re: Macro problem	#2
A23 Guest Posts: n/a	if you are using windows it might be the problem: windows xp

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
load sheme macro (Solv Execute Command macro)	manu	FLUENT	2	March 13, 2008 02:00
Problem with FLUID_THREAD_P(t) macro	Sciaco	FLUENT	0	November 18, 2007 03:23
Macro Trouble -Winows Explorer Crashes with Macro	Martin Castillo	FLUENT	1	July 25, 2007 05:18
TECPLOT 10 macro problem	Matthew Morse	Tecplot	5	July 5, 2004 02:31
Call a macro from a macro	Flav	Siemens	2	July 1, 2004 06:42