 |
 |
 |
|
|
|
[Sponsors] | ||||
August 18, 2006, 13:25
|
Bluff Body
|
#1 |
|
Guest
Posts: n/a
|
How can a mesh be generated in Pro Star for a flow taking place through a pipe with a cylindrical bluff body placed near the exit? Will deleting the cells corresponding to the bluff body location take care of flow separation?
|
|
|
||
|
August 18, 2006, 17:35
|
Re: Bluff Body
|
#2 |
|
Guest
Posts: n/a
|
it depends on how complex the body is, if it is a regular shape then you should be able to use vc3d but if its a bit more complex you might have to use block structured or even automeshing. Whether it captures flow separation depends on the resolution in the relevent regions.
|
|
|
|
||
|
September 16, 2006, 07:45
|
Re: Bluff Body *NM*
|
#3 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
November 4, 2006, 14:36
|
Re: Bluff Body *NM*
|
#4 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
November 7, 2006, 16:45
|
Re: Bluff Body
|
#5 |
|
Guest
Posts: n/a
|
i need any information about bluff body burner designe
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bluff body vortices | philippose | OpenFOAM Running, Solving & CFD | 14 | April 11, 2008 09:02 |
| bluff body and Y+ | justin | FLUENT | 3 | May 4, 2006 21:13 |
| RSM+bluff body | anto | FLUENT | 2 | March 1, 2006 10:39 |
| BLUFF BODY+ RSM | Anto | FLUENT | 2 | August 3, 2005 06:09 |
| Bluff body flows | Pratap | Main CFD Forum | 0 | August 15, 2004 06:49 |
Linear Mode
