|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
While running a transient analysis with mioving mesh I am getting the following kind of error. Will it affect the solution. How to avoid the kind of error.
WARNING #113 *** CELL 10238 BEING REMOVED HAS NON-ZERO SIDE AREAS - CHECK IN PROSTAR FOR POSSIBLE MESH MOVEMENT ERROR *** WARNING #113 *** CELL 10238 BEING REMOVED HAS NON-ZERO SIDE AREAS - CHECK IN PROSTAR FOR POSSIBLE MESH MOVEMENT ERROR Thanks in advance |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error CFX Mesh | Jorn | CFX | 2 | August 7, 2008 10:32 |
MESH ERROR | Francesco - University of Florence, Italy | CFX | 2 | April 24, 2008 11:10 |
Oscillatory mesh motion setup mesh flux ERROR | jaswi | OpenFOAM Running, Solving & CFD | 5 | August 23, 2007 04:41 |
Mesh error | Vanessa | FLUENT | 1 | June 6, 2006 04:34 |
Error while exporting mesh | Vidya Raja | FLUENT | 0 | March 4, 2006 20:11 |