|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello Everyone
is it possible to restart a pst file before one step. i mean last time step in my pst file is 4001. But i want to restart(Standart) the simulation after time step number 4000 .I know this situation is some strange. Is there any way to do it? Otherwise i have to wait 2 days more to get result which is exactly at time step number 4000. thanks in advence... furkan |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
analysis controls -> output controls -> ananlysis ouput
output frequency 1 backup frequency 50 (you can go for less than 50 but the memory occupied will be more) so when ever you go for restart analysis use casename.pst_3950 instead of casename.pst_4000 this may help all the best ..best regards anand |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
thanks Anand...
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
I got slight acuracy problems with a restart in transient and periodic cases (engine revolutions). So if there is no reason to stop (possibly writing out results at a certain time), let it be.
When this is your problem, in StarCD v3.2x you can give a time to start wrting out results in a *,pstt file. If the pstt file becomes to big on 32bit mashines , you can write a posdat.f to write out *.pst_<timestep> files. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Restart | selim | CFX | 1 | August 21, 2007 14:43 |
Restart | Orit Friedman | Main CFD Forum | 1 | December 29, 2005 14:41 |
restart | Jane | Siemens | 2 | March 26, 2004 02:33 |
restart | Dmitry | Siemens | 1 | March 27, 2002 10:26 |
restart | Dmitry | Siemens | 0 | March 22, 2002 10:28 |