|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
This seems to be a simple question. However can anyone tell me the significance of piezo swith in pressure boundary condition. More specifically what difference shall I expect in the results when I swith on piezo and static pressure respectively
Regards CFDian |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
piezo is active only when you have switched on gravity.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thank you for the reply. But I would like to know how does gravity relate to Piezo pressure.
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
All details are given in starcd manual.
When gravity is on the datum head will get added in the pressure. (pressure exerted by vertical fluid column above the point) |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
What type of pressure can give the pressure drop | david | FLUENT | 1 | February 17, 2014 11:51 |
Pressure driven laminar flow simpleFoam pressure higher at the outlet than inlet | gabriel | OpenFOAM Running, Solving & CFD | 16 | September 30, 2009 18:20 |
Forcing pressure outlet according to pressure prob | Cedric | FLUENT | 0 | July 29, 2005 11:49 |
pressure driven flow by pressure correction method | justentered | Main CFD Forum | 0 | December 29, 2003 23:52 |
Total pressure to static pressure ratio | roadracer | Siemens | 1 | April 17, 2003 05:31 |